Hello,
I'm having difficulty using the evaluation board for gyroscope ADXRS624.
I am applying +5V to pins 1 and 13, with ground on pins 8 and 12. I am reading pin 2 as the output.
Instead of receiving the 2.5V null output from zero rotation, I am detecting a signal that repeat every ~150us, and goes from 3.6mV to -3.6mV in four evenly spaced steps.
This seems like a very basic operation. I've already tested two of these devices and am getting the same response. Any help would be appreciated.
Thank you,
brsimon
