Clik here to view.
Unexpected output data read from ADIS16223
Hi everyone, Today I want to show some capture data that read from ADIS16223. [FIRST]As the picture showed, Z-axis presented stable, but X-axis and Y-axis have a lot of noise. In my code, I read the...
View ArticleADIS16334 Gyroscope and accelerometer data scaling to a more usable format
We are trying to get real time data from ADIS16334 with the EVAL-ADIS EVALUATION SYSTEM using the EvalAdisApi.dll. We have managed to get it to the point we are getting data out, but the format that...
View ArticleADXL345 as a seismic detector
Hi, I wish to add a simple seismic detector to a current project (environmental monitor).I have absolutely no experience in this field, but it looks useful and fascinating.Questions are:1. is this...
View ArticleADXRS646 calibration
Dear All. I have an application in which I have to measure the angle between a couple of rotating planar surfaces around a common joint. Just for giving you a picture, imagine you have to open a book...
View ArticleQuestion about gyro adis16266
Hello, I want to know how long the gyroscope(MENS technology) calibrated perfectly is capable of give me angle with precision, because I need precisión orientation only for 2 minutes with sudden...
View ArticleADIS16485 no data output, also no current consumption
Just received an ADIS16485 but are having some trouble to get data out. I am interfacing to the ADIS with an FPGA. My ADIS nRST is tristatedThere is 3V3 power on all the VDD pins, GND on all the GND...
View ArticleClik here to view.
ADXL362 unexpected behaviour
Hello everyone, I would like to use an accelerometer ADXL362 with a MSP430 uprocessor as a low-power pedometer, but even I tried almost all possible settings, I am still having problem with reading...
View ArticleReading data from ADIS16060
Hello!I'm trying to read out data from ADIS16060 using Stellaris LMF4120 microcontroller. Initially, hardware SPI driver was used in burst mode (3x8bit transactions at 2 MHz). After that I was switched...
View Article0.1mg acceleratometer
Hi,I'm working on structure health monitoring, I want to sense bridge and school movements when a person walk around,so after search and reading papers I found that I need high resolution accelerometer...
View ArticleADXL362 SPI Pins
What happens to the ADXL362 SPI pins when /CS is high? Are they tri-stated?
View ArticleAdis16209 Problems Getting Data From It
Hello! I am during some days trying to put working the ADIS16209. However, I'm not getting it.I started to try read the temperature register, but until now without success. #include <SPI.h> //...
View ArticleADIS16209 systematic drift on long timescales?
We were probably among some of the first users of the ADIS16209 inclinometer chip. We have about fifty of them installed inside environmental chambers which are embedded in a glacier, and have been...
View ArticleClik here to view.
ADIS16480 Register Writes to PAGE_ID 0x03 problems
Hi, I have recently connected an ADIS16480 to an MSP430 microcontroller to test some basic code (ultimate application is a bore-hole logging tool). I have run into a very strange problem when...
View ArticleADXL346/ADXL345/ADXL350 I2C broadcast address
Hi Does ADXL346/ADXL345/ADXL350 respond to I2C general call address?http://www.nxp.com/documents/user_manual/UM10204.pdf(See page 30 for general call address.) Regards, IN
View ArticleAccelerometer Applications
What are some of the coolest accelerometer applications that exist today?
View ArticleXL345 and XL346 Header files and utility routines
Attached are header files XL345 and XL346 Let me please comment if you find any issues.
View ArticleADIS16135 SPI Interface Configuration
How do I configure the ADUC7026 to communicate with the SPI on the ADIS16135?
View ArticleADIS16407 SPI Communication
I am not getting any data from the ADIS16407. What should I do?
View Articleaccelerometer offset change with age
Are there any data on the effects of short and/or long term aging effects on accelerometer offsets after a device has been soldered to a PCB?I'm using an ADXL346. Thanks. Edd
View Article
