ADXL345 / 350 offset problems
Hi, I have a question regarding ADXL350 operating voltage. It specifies 2.0 - 3.6V, the same as the ADXL345. However, I have seen from operating the ADXL345 @ 3.3V that there is significant offset on...
View ArticleADXL345 characterization data at 3.3V power supply is available?
Dear Sir,I have a question regarding ADXL345 operation voltage. It specifies2.0 V to 3.6 V.In the datasheet, ADXL345 is tested and specified at a supply voltage of VS = 2.5 V; however, it can also be...
View ArticleClik here to view.
ADIS16480 Position tracking Problem
I am trying to track the position of the ADIS16480 sensor by double integrating the accelerometer values. The ADIS16480 is meant to run in inertial frame so that the position is output in reference to...
View ArticleIssue when using ARMWSD to flash firmware of ISEB
I am trying to flash firmware of ISEB to accommodate ADXL312 satellite board, when running ARMWSD, there is no COM port select list showing up, so I can't select right COM port, the communication...
View ArticleClik here to view.
How to check if ADIS-16480 actually works ?
Hello, I have purchased an ADIS-16480 and tried to connect it to an Arduino board but I haven't been able to make it work. The programming of the Arduino should be fine, as my code is identical to...
View ArticleADXL345 Anti-Aliasing Filter specs
Hello, I am trying to work out what type of analog (anti-aliasing) filter the ADXL345 uses to acquire the signal before the A/D stage. I have already found out that it's a 2 pole low pass but I don't...
View ArticleADXL 362 / Activity Interrupt problem
Hello,I'm trying to generate an interrupt from the ADXL. The pin INT-2 should go high when the accelartion goes above the threshold and stays above for the in register ADXL362_REG_TIME_ACT specified...
View ArticleADIS16209: long stabilization time, incorrect output or wrong communication?
Hi.I'm currently working with an ADIS16209 (firmware developed in: VisualDSP++, controller: ADSP-2185) and am experiencing following strange behavior: temperature and supply take about 10 minutes until...
View ArticleADIS16203: need to get stable readings
Hi, everyone.I have recently been working with the ADIS16203 360 degree sensor. Can anyone tell me what kind of stable reading I should expect?As it is now the first digit after the decimal varies...
View ArticleEvaluating ADIS16227
Can the ADIS16227 evaluation board connect to one of the evaluation kits/platforms? I don’t see a specific evaluation document up on the website and the datasheet only shows the board with the part...
View ArticleHow to use ADXL 345
Hi,I'm working on a project to detect the inclination of hand using ADXL 345. Can anyone please tell me what are the materials should i read to know the basics about how to use ADXL 345, Hardware...
View ArticleADIS16480, Datasheet Error
Hi Mark,I think table 94 in the datasheet is wrong after some tests. I think EKF_CNFG[1] = 1 means disabling, while =0 means enable. Regarding other bits in EKF_CNFG, i am not sure whether the...
View ArticleADXL345 no response
Hi, I am using a evaluation board that consists of adxl345 accelerometer that comes along with aduc7024. The evaluation board is EVAL-ADXL345Z-DB. I am trying to trigger a free fall interrupt but it...
View ArticleHow could I start with adxl345?
I have just bought the adxl 345 breakout board. How could I start? What microcontroller could I use to monitor it and program it? What software could I use to program it through a microcontroller?...
View ArticleADXL362 rotate motion
Hi, Have any about ADXL362 rotate motion application notes, driver or others?Thank you!Kevin
View ArticleVehicle Hub-Mounted Odometer using MEMs devices
Gentlemen - My project is a wheel-hub mounted odometer using MEMs devices. It must be ultra low power in standby mode because it has to run a long time from batteries. It needs to detect rotation of...
View ArticleADIS16227 Interface
Do you have any reference code for using the ADIS16227 with my embedded processor?
View ArticleClik here to view.
ADXRS453 Q-bit error
HiI have 3 ADXRS453 sensors on a custom PCB that are all reporting a Q-bit error during the start up test. I have implemented the circuit as in Figure 25 and 26 from the datasheet for the SOIC and LCC...
View ArticleADIS16204 Code Examples
Nypop offered the following, in another post:I was wondering if there was any source code or sample code that was available for the ADIS16204 (only edit by NevadaMark). We are using a chipKIT Max32...
View Article
